Page 1 of 1

Stubborn blushing after neck reset

Posted: Mon Nov 02, 2015 10:34 pm
by Fren Asken
Working on an old 0017 and the blushing is pretty obvious on either side of the fretboard tongue, even after trying a gentle wipe with denatured alcohol. Any suggestions?

Image

Re: Stubborn blushing after neck reset

Posted: Wed Nov 04, 2015 10:44 pm
by Dave Weir
I used the Behlan's spray blush remover on an 1945 Gretsch that was my first (and last) neck rest. It worked kind of o.k. but I wouldn't say great. I was timid about using too much. I decided to just accept it. Two years later, the blush is completely gone.

Re: Stubborn blushing after neck reset

Posted: Thu Nov 05, 2015 12:07 am
by Fren Asken
I ended up lightly brushing retarder on the affected area and it worked great.

Re: Stubborn blushing after neck reset

Posted: Fri Nov 06, 2015 4:42 am
by Michael Lewis
Often just a light spray of lacquer thinner will remove the blush. Make sure the surface is clean before doing this because anything on it can become part of the finish. Brushing thinner on can work but if you have to go over the area more than once you can leave brush marks in the now softening finish. The spray leaves less "tracks".

Re: Stubborn blushing after neck reset

Posted: Sat Nov 07, 2015 11:07 am
by Clay Schaeffer
Behlen's and Mohawk's blush remover is mostly retarder (butyl cellosolve) in a handy spray can. Slowing the solvent evaporation allows the water vapor (blush) to escape. Using denatured alcohol can sometimes attract moisture rather than disperse it. "Slow" lacquer thinners usually retard drying and can also help remove blush.