How to wire 1pu with tone control pot but no volume control?
Posted: Fri Aug 09, 2013 11:51 am
Hello folks,
I built a lap steel with one single-coil pickup, which I wired directly to the output jack. It works fine. I would, however, like to add a tone control. I want to omit the volume control--mainly because I don't have room for it. I'm clueless about electronics and have not been able to find such a schematic on the web. There are, however, many schematics for just a volume control. Is it impossible to only have a tone control? Anyway, If any of you know where I might find such a schematic, or can suggest how I should proceed, I would be very grateful.
Many thanks,
Claude
I built a lap steel with one single-coil pickup, which I wired directly to the output jack. It works fine. I would, however, like to add a tone control. I want to omit the volume control--mainly because I don't have room for it. I'm clueless about electronics and have not been able to find such a schematic on the web. There are, however, many schematics for just a volume control. Is it impossible to only have a tone control? Anyway, If any of you know where I might find such a schematic, or can suggest how I should proceed, I would be very grateful.
Many thanks,
Claude