Squeegee for epoxy

[Steve Sawyer]

This tool has turned out to be just about perfect for spreading epoxy for grain-filling:

4020_sili_glue_kit_5_300.jpg (23.56 KiB) Viewed 7700 times

It's called a Sili-Comb, and comes in a set with several other silicone glue applicators that are also real handy to have around. I don't have any single glue-spreading tool, but switch between these silicone tools, brayers (the rollers for applying ink to carved linoleum-blocks for printing) , closed-cell foam rollers for spreading veneer glue, popsicle sticks, toothpicks, etc. etc.

Anyway, I used a conventional squeegee that I hacked into a smaller, 3" width for spreading epoxy, but this is actually much easier to handle.

[Peter Wilcox]

I use old credit (or AARP ) cards for epoxy, and a toothed credit card (made in about 15 seconds with a bandsaw) for spreading glue over surfaces. Works for me, and the price is right.

[Steve Sawyer]

I use old credit (or AARP ) cards for epoxy, and a toothed credit card (made in about 15 seconds with a bandsaw) for spreading glue over surfaces. Works for me, and the price is right.

I hoard "credit cards" (key cards from hotels, emptied gas & gift cards etc.) and find dozens of uses for them, but find them too aggressive for spreading epoxy.

OTOH cheap sheet metal mastic spreaders from the hardware store w/ 3/32" tooth spacing are perfect for some glue spreading, especially for veneering.

[Gordon Bellerose]

I use different squeegies for different parts of the guitar.
I have 2 short (I cut down 2 - 8 inch to about 3 inch) for the sides and cutouts.
One I trimmed to a convex shape, the other I trimmed to a concave shape.
Then I have another longer 10 inch for the flat surfaces.
As long as I use alcohol to clean them after use, they last for a long time.

I even use my gloved hands on certain portions, especially where runs are possible on the sides, just to clean up at the end of application.