Slow build log - not much defined on this one yet

[Eric Baack]

Got the Amber dye on. Have since started working on the burst. It has gotten a bit dark so I may wash some dye out with warm water. Here it is with the Amber over sanded back dark brown.

[Eric Baack]

Got some shellac on it to seal it up. Still contemplating what method for filling the grain. There are some others in the grass but they are a bit washed out for lighting.

[Eric Baack]

frets are leveled and crowned.

Damn I need to get a crowning file. Crowning with the triangle file is a bit of a pain. I at least rounded the edges of the file so I wouldn't cut through the tape on the fretboard with one slip.

[Mark Swanson]

I good fret file is a great investment. Don't waste your money on anything else- get the diamond file.

[Eric Baack]

Whoops. Messed up spraying the burst. Gotta sand it off and try again. Got some good practice with the airbrush at least and the color is good.

[Eric Baack]

And after trying again, I got the burst looking great and went to seal it with shellac out of a spray can.....

And the new layer melted into the burst and made it blotch really badly

Glad I did a seal coat first! I'll sand back to the seal coat again and try and do the layer over the burst with a gun or the airbrush instead. I think the mist out of the can was too thick. A finer mist laid on with very thin layers for my tie coat before the 2 part clear should work a bit better.

[Mark Swanson]

The first coats over the burst need to be very thin and quick coats. I would have used lacquer for this.

[Eric Baack]

thanks for the tip, I'll do that after sanding it down

[Eric Baack]

I was planning to finish with a 2 part automotive grade clear. Would that be a problem over a typical lacquer? I've sprayed it over shellac before with no problems

[Barry Daniels]

That will likely not work well. Always try unusual combinations on scrap before committing to final project.

[Chuck Tweedy]

in general, everything works over shellac. it is fantastic in that respect.
it is very dangerous to assume that anything else has that property.

[Eric Baack]

2k clear over shellac is holding up well on my latest finishing job

[Eric Baack]

Got a little logo made by the fellow on Reverb.com

[Bob Francis]

Sweet!
Is that an inlay or transfer?

[Eric Baack]

that's a transfer. I might re-do it though. I didn't buff out the finish under it so it shows through after I sprayed a little clear over it.

[Eric Baack]

Not exactly a glamour shot but here is the burst. New help worked well

[Dan Smith]

Look's great Eric!

[Eric Baack]

New HVLP, not new help.....

[Randolph Rhett]

Ahh.. I wondered what the new "help" was.

[Eric Baack]

Well crap......

Burned through the burst while scuff sanding. Going to try to fix it with the airbrush or else it will be the third time sanding the burst off to try again.