EBOW mk1 schematic

Geoff James · Post by **Geoff James** » Mon Aug 13, 2012 4:00 am

Hi --for those interested , i recently took apart an ebow (messy job) and the following was revealed.

Geoff James · Post by **Geoff James** » Mon Aug 13, 2012 4:06 am

Hi again , forgot to label pin 8---pin 1 connects to pin 8 via a 10 ufd cap.

Post by **Mark Swanson** » Mon Aug 13, 2012 7:23 am

What is the IC in there?

Geoff James · Post by **Geoff James** » Mon Aug 13, 2012 11:26 am

Hi Mark , the chip, once cleared of the bullet proof resin, had no markings . I figure it had been sanded off.
The best guess is a LM386. I built a copy of the curcuit using a 386 , had to improvise on the inductors ,but hey it worked.
There will have to be a bit of fine tuning. I intend to use this as a sustainer , not as a hand held Ebow.
Regards
Geoff

MIMF

EBOW mk1 schematic

EBOW mk1 schematic

Re: EBOW mk1 schematic

Re: EBOW mk1 schematic

Re: EBOW mk1 schematic